Filter
Top Products
~-...-
..
=-=
---=--
Operating Ti~s
If your UBC6OXLT is not perfoming properly, try the steps listed below.
21
------
CONDITION SUGGESTION
Scanner doesn't tum
Rotate the Volume control to the
on.
right.
Check the Batteries for correct
installation.
Check the power level of the
Batteries. Replace or recharge
Batteries as necessary.
Check the (optional) AC Adaptor!
Charger or the (optional) Cigarette
Lighter Adaptor for a good
electrical contact at the scanner.
Make sure there is power at the
AC outlet (or the vehicle's
cigarette lighter).
Check the in-line fuse on the
(optional) Cigarette Lighter
Adaptor cord. If blown, replace it
with the same type of fuse.
Poor reception.
Check the antenna connection.
Make sure the antenna is in a
vertical position.
If you're inside a building, move
the scanner to a window, an
outside wall, or outdoors.
Check for sources of interference
such as computers, microwave
ovens, or other electrical devices.
Move the scanner as necessary.
You may be too far away from
the stations using the frequencies
you have programmed. Try
another location, or program
frequencies for stations closer to
your area.
Scanner doesn't receive
Adjust the Squelch setting. It
weather channels.
may be too high.
In some parts of the country, you
Note: Currently Weather
may not be able to monitor
Broadcast is not
weather broadcasts, such as in
available in Australia.
Iow lying areas. Move the
scanner to a higher location.
Reception may be poor. See
above for suggestions.