Filter
Top Products
29
Operation
2 seconds after the end of a transmission before
scanning proceeds to the next channel. To turn
the function off or on, press Func + Dly.
• If you enter a frequency that has already been
entered elsewhere, the scanner sounds an error
tone and displays the channel that was
duplicated. If you entered the frequency by
mistake, press Clr then enter the correct
frequency. To enter the frequency anyway, press
E to accept.
4. To program the next channel in sequence, press
E/Pgm then repeat Steps 2 and 3.
Searching For and Temporarily
Storing Active Frequencies
If you do not have a reference to frequencies in your
area, use a search to find a transmission.
Note: When the scanner starts searching, it auto-
matically turns on the delay function. To turn delay
on or off, press Func + Dly.
Service Search
You can search for aircraft and FM CB transmis-
sions without knowing the specific frequencies used
in your area. The scanner is preprogrammed with all
the frequencies allocated to these services. To use
this feature, press Func + Svc. SRCH appears and
the scanner searches starting with the aircraft
service bank. To select a different service bank,
repeatedly press Func + Svc. Service mode
appears on the display.
When the scanner stops on a transmission, press
Hold to stop searching and listen to the
transmission. Hold appears. In this mode, you can
UB323 Paper OM reduced size.fm Page 29 Tuesday, February 1, 2005 11:53 AM