Filter
Top Products
27
Beep Alert
The scanner can alert you with three beeps at the beginning of a transmission on an
assigned frequency.
Assigning the Beep Alert to a Channel
This alert can be set ON/OFF for every channel.
1. Press
MENU.
2. Select
2:SCAN OPTION by rotating the VFO and pressing E.
3. Select the channel number by rotating the
VFO and pressing E. You can also enter the
channel number by using the keypad and pressing
E.
4. Select
4:BEEP ALERT by rotating the VFO and pressing E.
5. Select
1:ON or 2:OFF by rotating the VFO and pressing E.
Note: If NOT REGISTERED appears, make sure a frequency is stored in the channel.
☞ Remember! You can also use ▲ or ▼ instead of rotating the VFO.
Also instead of pressing
E, you can press the VFO control.
Programming Tips
• Group similar services into a bank. For example, program police frequencies in channels 1
through 10 and fire/emergency into channels 51 through 60, and so on.
• Put the frequency that you listen to the most or the most important frequency into a
Priority channel.
• To quickly program a series of channels, start with the lowest number channel.
For example, when you are programming five new frequencies into channels 4 through
8, start with channel 4. After you finish programming a channel, rotate the
VFO up or
press
▲ to go to the next higher channel.
• Write down your programmed channels and frequencies and put them in a convenient
place in case of accidental reprogramming.
• Frequencies are rounded off according to the step of each channel.
• When you are overwriting a tagged channel with a new frequency, the previous alpha tag
will be deleted. Re-register the alpha tag.
• When programming frequencies, a 2 second delay is set automatically but can be
changed in the menu mode.
UB343ZH_UBC785XLT_OM_0622 6/22/06 3:01 PM Page 27