Filter
Top Products
43
6. Press SCAN on both scanners.
The data transfer begins from the Master Unit to the Slave
Unit.
During the data transfer, both scanners show the following
displays.
When the data transfer is complete,
COMPLETE displays.
If the data transfer is not successful, the following error
message will appear.
Note: • To clear ERROR, press (decimal key).
To exit the Clone mode, press
MENU repeatedly.
Note • Once you have completed the cloning of the scanners, reset the scanners by
turning the scanners OFF and then ON again. This is particularly important to know
if you wish to clone another scanner right away.
☞ Remember! You can also use ▲ or ▼ instead of rotating the VFO.
Also instead of pressing
E, you can press the VFO control.
.
CLONE
== >
MASTER UNIT
CLONE
== <
SLAVE UNIT
CLONE
COMPLETE
MASTER UNIT
CLONE
ERROR
MASTER UNIT
UB343ZH_UBC785XLT_OM_0622 6/22/06 3:01 PM Page 43