Filter
Top Products
28
Operation
2 seconds after the end of a transmission before
scanning proceeds to the next channel. To turn
the function off or on, press Func + Dly.
• If you enter a frequency that has already been
entered elsewhere, the scanner sounds an error
tone and displays the channel that was
duplicated. If you entered the frequency by
mistake, press /Clr then enter the correct
frequency. To enter the frequency anyway, press
E to accept.
4. To program the next channel in sequence, press
E
/P
gm then repeat Steps 2 and 3.
Searching For and Temporarily
Storing Active Frequencies
If you do not have a reference to frequencies in your
area, use a search to find a transmission.
Note: When the scanner starts searching, it auto-
matically turns on the delay function. To turn delay
on or off, press Func + Dly.
Service Search
You can search for aircraft and FM CB transmis-
sions without knowing the specific frequencies used
in your area. The scanner is preprogrammed with all
the frequencies allocated to these services. To use
this feature, press Func + Svc. SRCH appears and
the scanner searches starting with the aircraft
service bank. To select a different service bank,
repeatedly press Func + Svc. Service mode
appears on the display.
When the scanner stops on a transmission, press
Hold to stop searching and listen to the
transmission. Hold appears. In this mode, you can
UB324 Paper OM reduced size.fm Page 28 Wednesday, February 2, 2005 8:01 PM