Uniden UBC92XLT Scanner User Manual


 
29
Operation
press Func + or Func + to step through the
frequencies.
To release the hold and continue searching, press
Hold. Or, if you did not press Hold, simply press
Func + or Func + to continue searching.
Storing Frequencies into Channels
During Service Search
You can store frequencies you found during service
search or service search hold mode into channels.
1. Press Func and Pgm during service search or
service search hold mode. The frequency and
the lowest blank channel alternately appear.
2. Press E/Pgm to store the frequency into the
blank channel. If you want to select another
channel, press Func + or Func + before
you press E/Pgm. You can also use the 0-9 key
to select the bank.
If you entered a frequency that has already been
entered elsewhere, the scanner sounds an error
tone and displays the channel that was duplicated.
If you entered the frequency by mistake, press /Clr
then enter the correct frequency. To enter the
frequency anyway, press E to accept.
Scanning the Stored Channels
To begin scanning channels, press Scan.
The scanner scans through all non-locked channels
in the activated banks. (See “Locking Out Channels”
on Page 39 and “Turning Channel-Storage Banks
On and Off” on Page 38). When the scanner finds a
transmission, it stops on it. When the transmission
ends, the scanner resumes scanning.
UB324 Paper OM reduced size.fm Page 29 Wednesday, February 2, 2005 8:01 PM