Filter
Top Products
Page 8
SECTION 2 SETUP AND OPERATION
ASSEMBLING THE L60
Using a square, mount the Unwind Assembly to the back of the L60 using the 2
screws provided. The top screw is a ¼-20x1-1/2” socket head cap screw, the
bottom screw is ¼-20x1-1/4”.
Maximum reliability is assured when the Compressed Air supplied to the L60 is
Clean & Dry. Over time, moisture will take its toll on the Solenoid Valves and Air
cylinder. Also it is not recommended to add Oil to the Compressed Air line supplied
to the L60. The air valves and air cylinder will eventually fail and oil will end up on
the label from the Air Assist tube which helps feed the label on to the vacuum head.
This will cause the label to not adhere properly to the product.
Run 40 psi @5CFM minimum compressed air to the L60 and procure necessary
fittings to make the connection to the air inlet located on the side opposite the label
drive and rewind. DO NOT CONNECT THE AIR TO THE UNIT AT THIS TIME.
Please
note:
Screws.
Top one is
longer.
Fig 3