Filter
Top Products
48 • BIOS Setup
KB Power ON Password:
You can use this item to limit operating KB Power On system.
The choice: Enter
Hot Key Power ON:
You can use this item to select operating Hot Key to Power On system.
The choices: Ctrl-F1~Ctrl-F12.
Onboard FDC Controller:
Select “Enabled” if your system has a floppy disk controller (FDC) installed on the
system board and you wish to use it. If you install and-in FDC or the system has no
floppy drive, select Disabled in this field.
The choices: Enabled, Disabled.
Onboard Parallel Port:
This item allows you to determine access onboard parallel port controller with which
I/O address.
The choices: 3BC/IRQ7, 378/IRQ7, 278/IRQ5 and Disabled.
Parallel Port Mode:
Select an operating mode for the onboard parallel (printer) port. Select Normal,
Compatible, or SPP unless you are certain your hardware and software both support
one of the other available modes.
The choices: SPP, EPP, ECP and ECP+EPP.
EPP Mode Select:
Select EPP port type 1.7 or 1.9.
The choices: EPP1.7, 1.9.
ECP Mode Use DMA:
Select a DMA channel for the parallel port for use during ECP mode.
The choices: 3, 1.
PWRON After PWR-Fail:
This item allows you to select if you want to power on the system after power failure.
The choices: Off, On and Former-Sts.
Onboard Lan Boot ROM:
Select “Enabled” if your system has a LAN device installed on the system board and
you wish to use it.
The choices: Enabled, Disabled.