Filter
Top Products
6
In this example, the VIP-810 is connected to the data network jack already installed and now the network
connected telephone can reach into the existing Valcom V-2924A to access all call priority paging. This
configuration could be used at a guard shack where network access is available, but not a telephone.
There are many buildings or areas with existing 70 Volt paging speakers and amplifiers installed.
Often times these systems are not operational or do not provide adequate coverage. The VIP-800 is
ideally suited for integration with conventional paging products. They can be used to interconnect
buildings for paging without the need of additional wire runs. Once connected through the LAN or
WAN, the VIP-800 provides line level outputs and auxiliary contact closures that can be interfaced
with conventional amplifiers. The illustration shown below depicts how integration is accomplished.
From a central location, paging can be accomplished either by specific zone or all call mode.
VIP-800
V-2924A
Override Audio
Page Input
Network
LAN
OR
WAN
VIP-810
PBX
VIP-800
70 VOLT SYSTEM
Zone 1 Audio
VIP-
8
Network
LAN
OR
WAN
V-1095
Note: During initial SETUP, the “Sub-Net Address” and the “Gateway MAC Number (address) of
the Sub-Net Power” must be programmed in the software of each unit locally - on the SubNet on
which the unit resides.