Filter
Top Products
31
What to do when these messages are displayed
Message Cause (Details)
No device is connected to the DVI terminal.
The terminal is connected but there is no signal output.
➝ Input the video signals.
When lamp time reaches 1000 hours
➝ A message indicating “1000 h” will be displayed on the screen.
• Press the [EXIT] button to clear the display.
At the moment when the accumulated lamp time reaches 1900
hours, a “Lamp replacement” message will be displayed. In addition,
when the accumulated lamp time reaches between 1900 hours to
2000 hours, the “Lamp replacement” message will be displayed
each time the projector is turned on.
• The message can be cleared by pressing the [EXIT] button or dis-
playing the menu.
➝ replace the lamp as soon as possible.
The “Warning” word appears and blinks when the accumulated lamp
time exceeds 2000 hours. The message can be cleared by pressing
the [EXIT] button. However, the same message will reappear every
hour. When the accumulated lamp time exceeds 2000 hours, the
unit cannot be turned on again once it is turned off . If continuous
projection is performed after 2000 hours, the unit will shut down
upon exceeding 2010 hours and projection will be disabled.
➝ Install a new lamp and reset the lamp time.
(Page 29)
No Signal DVI-D
1000h
EXIT
●
EXIT
●
Lamp replacement
Warning
EXIT
●
Lamp replacement