Filter
Top Products
16 ViewSonic PJ750
No Signal Menu
The same adjustments and settings are available as with the Image and
Options menus when the MENU button is pressed during display of
the “NO INPUT IS DETECTED ON***”or “SYNC IS OUT OF
RANGE ON***”message while no signal is received. Select an item
with the and buttons, and start or stop the operation with the
and buttons.
Table 8: No Signal Menu
Item Description
VOLUME
Reduce Increase
• When this function is used, audio input is automatically switched to video. The
audio input can be switched by moving the DISK PAD left and right during the
display of the volume adjustment bar. The volume adjustment bar is displayed by
pressing VOLUME button.
BLANK
Select Blank Screen Color:
Select the color with the button.
• When the blank mode is set with BLANK ON, without a signal, or with a non-
standard signal, the image is cleared and the complete screen is displayed in the
selected color.
MIRROR
Select Mirror Status:
Select the mirror status with the button.
START UP
Setup Initial Screen Display:
Select the TURN ON with the button.
Clear Initial Screen Display:
Select the TURN OFF with the button.
• Note that if TURN OFF is selected the blank screen is displayed in blue when
there is no signal.
MENU COLOR
Select Menu Background Color:
Select the color with the buttons.
LANGUAGE
Select Menu Display Language:
Select the language with the buttons.
AUTO OFF
Set AUTO OFF:
Set 1-99 minutes with the buttons. The system
automatically enters the standby mode when a signal is not detected for the set
time.
Clear AUTO OFF:
Select the STOP (0 min.) with the button. When the STOP
is selected the system does not enter the standby mode even if no signal is
received.
SYNC ON G
SYNC ON G Valid:
Select the TURN ON with the button.
SYNC ON G Invalid:
Select the TURN OFF with the button.
• May not be displayed correctly with some input signals when the SYNC ON G is
valid. In such cases, remove the signal connector so that no signal is received,
set the SYNC ON G to invalid, and reconnect the signal.
WHISPER
Set / Clear WHISPER Mode:
Press the button. When WHISPER is
selected, the WHISPER mode is active. In the WHISPER mode, acoustic noise
level from the unit is reduced, and brightness level on the screen is a little lower.