Filter
Top Products
4 ViewSonic PJ700
E
N
G
L
I
S
H
Setting up the Projector
1 Connect the Power Cord and Input/Output Devices.
Make sure that you have properly connected the power and input cables before turning on the
projector. See “Connecting Input and Output Devices” on page 5.
2 Remove the lens cap.
3 Turn on the Projector.
• Turn on the Power Switch on the side of the projector. The power indicator (LED) lights a
steady orange. See “Using The Projector” on page 8.
4 Press the Standby/On button.
• The power LED flashes green during warm-up.
• The power LED lights a steady green after warm-up. The steady green light indicates that the
ViewSonic PJ700 is ready to use.
•
To turn off the lamp, press (and hold for 2 seconds) the Standby/On button. The power LED
flashes orange and the unit remains in cool-down mode with the fan on for approximately 1
minute. The power switch on the side of the projector can be turned off when the power LED
lights a steady orange, indicating that cool-down is complete.
5
Position the Projector.
• Position the projector on a level and stable surface. Determine the distance the projector will be
from the screen. (See “Positioning the Projector” on page 6.)
• Adjust the angle of the projection by positioning the foot adjusters. (See Figure 5 :"Angle
Adjustment" on page 7.)
6 Turn on the Input Devices and select the Input Signal.
• Press either the Input button on the projector control pad or the Video/RGB buttons on the
remote control to select the signal to be projected.
•
The selected input signal source displays in the lower right section of the screen.
7 Adjust the image size.
• Turn the Zoom ring to adjust the size of the projected image.
8 Adjust the Focus.
• Turn the Focus ring to adjust the focus.
9 Adjust the Keystone Control.
• If the top of the projected image is not the same width as the bottom, use the Keystone control.
See “Keystone” on page11.
Caution: The projector requires a warm-up period (approximately 45 seconds) after the power is
turned on and a cool-down period (approximately 60 seconds) after the power is turned off.
NOTE:
The power cannot be turned on for at least 1 minute after the unit has been turned off. This is
a safety feature.