Filter
Top Products
P
P
P
r
r
r
e
e
e
f
f
f
a
a
a
c
c
c
e
e
e
– 51 –
LED Error Messages
ERROR CODE MESSAGES
POWER LED
BLINK
READY LED
BLINK
TEMP LED
BLINK
Over temperature OFF OFF ON
G794 fail 4 4 OFF
T1 fail 4 5 OFF
Lamp error 5 OFF OFF
Fan1 error (Burner Fan) 6 1 OFF
Fan2 error (Lamp Fan) 6 2 OFF
Fan3 error (Power Fan) 6 3 OFF
Fan4 error (DMD Fan) 6 4 OFF
Lamp door open 7 OFF OFF
DMD error 8 OFF OFF
Color wheel error 9 OFF OFF
Ballast error 10 OFF OFF
Ballast communication error 10 1 OFF
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before re-
starting the projector. If the POWER or RESDY LEDs are still blinking or the TEMP LED is lit, contact
your service center.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Press the Auto button on the remote control or projector.
3. Ensure the projector-to-screen distance is within the 10-meter (33-feet) specified range.
4. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control or projector to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Installation I menu of the OSD.
Problem: The image is streaked
1. Set the Frequency and Tracking settings on the Computer menu of the OSD to the de-
fault settings.
2. To ensure the problem is not caused by a connected PC’s video card, connect to another
computer.
Problem: The image is flat with no contrast
Adjust the Contrast setting on the Image menu of the OSD.