Filter
Top Products
TL-WN727N Wireless Lite-N USB Adapter User Guide
- 16 -
I. PBC Method
If your Access Point is equipped with a push-button for Wi-Fi Protected Setup, you can connect
the adapter to the Access Point by Push QSS Button method.
Step 1 Click the QSS button (marked by the red circle) on the screen as Figure 3-8.
Or: Press
and hold the QSS button on the adapter (shown on the following figure) for 2 or 3
seconds.
Step 2 Press the QSS button on your Access Point device to build the connection.
II. PIN Method
If your Access Point supports Wi-Fi Protected Setup and the PIN method, you can add the
adapter to the network by the following two ways:
1) Enter a PIN from my Access Point
Choose the Config Mode as Registrar and enter the PIN of AP into the field under the Pin Code
as Figure 3-9 shown. And then click PIN button to
start the wireless connection
without doing any
configuration for AP.
Figure 3-9 QSS - registrar mode