Filter
Top Products
Advanced Data Formatting
10-9
Special Commands
Pause Duration
This parameter along with the Send Pause parameter on page 10-33 allows a pause to be
inserted in the data transmission. Pauses are set by scanning a two-digit number (i.e., two
bar codes), and are measured in 0.1 second intervals. For example, scanning bar codes “0”
and “1” inserts a 0.1 second pause; “0” and “5” gives a 0.5 second delay. Numeric bar
codes begin on page D-1 in Chapter D, Numeric Bar Codes. In case of an error, or to
change the selection, scan Numeric Cancel on page D-6.
Pause Duration
Begin New Rule
Scan this bar code to start entering a new rule
.
Begin New Rule
Save Rule
Scan this bar code to save the entered rule.
Save Rule