Filter
Top Products
WLS 8400 Product Reference Guide
10-32
Setup Field(s)
Table 10-1. Setup Field(s) Definitions
Parameter Description Page
Move Cursor
Move Cursor To a Character Scan the Move Cursor To Character bar code on page
10-33, then any printable ASCII character from the
Alphanumeric Keyboard. When this is used, the
cursor moves to the position after the matching
character. If the character is not there, the rule fails
and ADF tries the next rule.
10-33
Move Cursor to Start of Data Scan this bar code to move cursor to the beginning of the
data.
10-33
Move Cursor Past a Character This parameter moves the cursor past all sequential
occurrences of a selected character. For example, if the
selected character is ‘A’, then the cursor moves past ‘A’,
‘AA’, ‘AAA’, etc. Scan the Move Cursor Past Character
bar code on page 10-33, then select a character from the
Alphanumeric Keyboard. If the character is not there, the
cursor does not move (i.e., has no effect).
10-33
Skip Ahead “N” Characters Scan one of these bar codes to select the desired number of
positions to move the cursor ahead.
10-34
Skip Back “N” Characters Scan one of these bar codes to select the desired number of
positions to move the cursor back.
10-36
Send Preset Value Send prefix and/or suffix value by scanning the appropriate
bar code. These values must be set using the Scan Prefix
and Scan Suffix bar codes on page 9-6.
10-38