WatchGuard Technologies V10 Network Card User Manual


 
CHAPTER 1: Hardware Descriptions
6 Vclass
lights labeled 10 and 100. These LEDs indicate the
speed of traffic being transmitted.
High Availability Status LED
Indicates the current status of this appliance, if it is
one of two connected as a high-availability system.
If this is the primary appliance, and the light is on
and steady, the system is functional, and this
appliance is on-line. If this is the primary appliance
and the LED is blinking, a failover has occurred
and the secondary appliance is online.
High Availability Interfaces
Two Ethernet interfaces, labelled HA2 and HA1
enable you to connect with a cross-over Ethernet
cable to other High Availability-ready Firebox
Vclass appliances for failover (backup) protection.
Incorporated into the two high-availability
Ethernet ports are two indicator lights labeled 10
and 100. These LEDs indicate the speed traffic is
transmitted.
Console Interface
A single RJ-45 interface, labeled Console, permits a
direct workstation-to-appliance connection. You
can use the WatchGuard Command Line Interface
(CLI) to configure and administer this appliance.
For more information about this administrative
option, see the CLI Guide.
Ready
Blinks when the appliance is powering up.
Illuminates when the appliance is ready for
network traffic.
Admin
Illuminates when a system administrator is
connected to the appliance by means of the
Vcontroller or the WatchGuard CLI.