Filter
Top Products
59
The malfunctions shown in the left-hand column below, labelled “Fault,” do not necessarily indicate functional
faults of the machine. It is therefore advisable to refer to the “Checking” shown in the right-hand column before
calling for service.
Error code table
When the following error codes are displayed, press the
c
key and take a proper action according to the table
below.
Fault Checking
The display won't be illuminated even when
the mode switch is turned to any other
position than “ ”.
• Is power supplied to the electrical outlet?
• Is the power cord plug out or loosely connected to the
electrical outlet?
(1)
The display is illuminated, but the whole machine
refuses registrations.
• Is a cashier code assigned to the register?
• Is the mode switch set properly at the “REG” position?
(2)
No receipt is issued. • Is the paper roll properly installed?
• Is there a paper jam?
• Is the receipt function in the “OFF” status?
• Is the print head release lever at the printing position?
(3)
No journal paper is taken up. • Is the take-up spool installed on the bearing properly?
• Is there a paper jam?
(4)
Printing is unusual. • Is the print head release lever at the printing position?
• Is the paper roll properly installed?
(5)
Before calling for service
10
Error
Error status Action
code
E01 Registration error Make a correct key entry.
E02 Misoperation error Make a correct key entry.
E03 Undefined code is entered. Enter a correct code, or declare it by the programming.
E07 Memory is full (in the
`
key programming). Program the
`
key within 25 steps.
E11 Compulsory depression of the
Ñ
key for direct Press the
Ñ
key and continue the operation.
finalization
E12 Compulsory tendering Make a tendering operation.
E22 Overlapped cashier error
E23 Cashier resetting over error
E32 No entry of a cashier code Make a cashier code entry.
E34 Overflow limitation error Make a registration within a limit of entry.
E35 The open price entry is inhibited. Make a preset price entry.
E36 The preset price entry is inhibited. Make an open price entry.
E37 The direct finalization is inhibited. Make a tendering operation.
E67 Subtotal void is not allowed. Finalize the transaction, and correct the wrong entries in the
void mode.