Filter
Top Products
030-300331 Rev. A 12 October 2002
4-Port Router (Model 2400)
User Guide
6. INSTALL THE USB DRIVERS
This section explains how to install the USB modem drivers for the 4-Port Router. If you are using only Ethernet
ports, USB driver installation is not necessary. The Microsoft® Plug and Play auto-detect feature recognizes when
new hardware has been installed. After you connect the Router to the PC, the Router will automatically be detected.
Before you begin the USB driver installation, you must determine which operating system is installed on your PC.
To view information about your operating system, go to the ‘My Computer’ icon located on your desktop and then
right click. Next, select ‘Properties’ from the options displayed, the ‘System Properties’ box will appear. At the
‘System Properties’ box, click on the ‘General’ tab. This will display the ‘System Properties’ for your PC, including
the operating system installed on your PC (e.g. Microsoft Windows 98).
6.1 Westell CD-ROM Installation:
1. Place the Westell CD-ROM that you received in the Router kit into the CD-ROM drive of the PC that is
connected to the USB port.
2. Go to the USB driver installation section that matches your operating system and follow the procedures outlined
in that section.
3. Verify the connection to the computer by observing the state of the USB LED. Once the USB drivers have been
installed, the USB LED should be solid green. Solid green indicates a USB connection has been established.
Refer to Table 1 (LED States and Descriptions) in section 4.4 of this User Guide.
6.2 Installing the USB Drivers for Windows 98
IMPORTANT: Confirm that the Westell USB Driver CD-ROM is inserted in the appropriate drive before continuing this installation.
1. After you have connected the Router to your PC, the New Hardware Found window appears See Figure 5. In a
few moments, the Add New Hardware Wizard window will open. See Figure 6. Click Next.
Figure 5. Windows 98
!