Filter
Top Products
4-2
IPS-800CE-D16 & IPS-1600CE-D16 - User’s Guide
4. Connect the power cables to the power inlets. Check to make sure
that both cables are firmly seated in the power inlet connectors.
5. Align the power cables with the two notches in the top of the slider
plate, and then move the slider plate forward until both cables are
held firmly in place.
6. Tighten the two screws that secure the slider plate to the bottom
plate. Check to make certain that the cables are held firmly in place
by the cable keepers.
4.2. Connection to Switched Outlets
Connect the power cord from your switched device to one of the AC Outlets on
the IPS unit. Note that when power is applied to the IPS, the AC Outlets will
be switched "ON" by default.
Note that both the IPS-1600CE-D16 and IPS-800CE-D16 feature two separate
power busses. Each bus can support a total of 16 Amps, and each individual
AC Outlet can support up to 10 Amps.
4.3. Serial COM / RS232 Port Connection
The COM Port is a male, RS232C DB9 connector, wired in a DTE
configuration. In the default state, the COM port is configured for 9600
bps, no parity, 8 data bits, 1 stop bit. The COM Port can be connected to
either an external modem or a local PC, but not both items at the same time.
Appendix A describes the COM Port interface.
IPS UNIT
POWER INLETS
BOTTOM
PLATE
SLIDER
PLATE
SCREW
RECEPTACLES
Figure 4.1: IPS-800 Series Cable Keeper Installation