Filter
Top Products
5-10
IPS-400 / IPS-400-CE - User’s Guide
As shown in Figure 5.5 and Figure 5.6, the Serial Parameters Menus offer
the following options:
• Baud Rate: Baud Rate for the Console Port. (Default = 9600 bps.)
Note: When this setting is changed, the new baud rate will not be
applied until the user exits and then re-enters command mode.
• Data: The Data Bits setting for the Console Port. (Default = 8 Bits.)
• Parity: The parity setting for the Console Port. (Default = None.)
• Stop: The Stop Bits setting for the Console Port. (Default = 1 Bit.)
• Port Mode: Sets up the serial Console / RS232 Port for use with
either a local PC or an external modem. Note that when the Port Mode
is set to "Modem" the modem initialization string will be sent every 15
minutes. (Default = Console.)
• Modem Initialization String: Defines a command string (up to
32 characters long) which can be sent out the serial Console Port to
initialize an external modem. If the Port Mode is set to "Console",
the modem initialization string will not be sent. For more information
on initialization commands, refer to the user’s guide for your modem.
(Default = ATE0M0Q1&C1&D2S0=1)