Filter
Top Products
Switched AC Outlets (Plugs 1 - 5): For connection to up to five AC devices. Each
outlet is capable of switching up to 15 Amps. The total for all five outlets must not
exceed 15 Amps.
1.
SetUp Switches (RATE): A bank of four DIP Switches which set the Control Port
baud rate, select the Off Time duration, enable/disable the Password Option, and
enable/disable the Read Only Mode.
2.
RS232 (Control) Port: For connection to an external modem or local PC. The
RPB+ accepts ASCII commands via the Control Port.
3.
DEFAULT Button: Reads Rate Switch settings and sets parameters accordingly.
This allows the user to change Rate Switch settings without re-booting the RPB+ and
connected devices. The Default Button can also be used to bypass the Password
Prompt.
4.
Power Cable (115 VAC Units)
Power Cable Receptacle (230 VAC Units)
5.
Circuit Breaker: 15 Amps6.
Power Switch7.
3. Installation
3.1. SetUp Switches
The SetUp Switches select the baud rate and Off Time, and enable/disable the Password
feature and Read Only Mode. If switch settings are changed while the unit is powered On,
press the Default Button to re-read switches. The Default Button allows the user to change
switch settings while power is on, without re-booting the RPB+ and connected devices.
Note: If Rate Switch settings are changed while the unit is powered on, new
parameters will not take effect until the Default Button is pressed, or the RPB+
is powered Off and On.
Off Time: When a boot cycle is initiated, the "Off Time" determines the length of time the
device will remain off until power is restored.
Password: When enabled, a password is required in order to access the RPB+ Command
Mode (Default = [Enter]). To re-define the Password, refer to Section 4.
Read Only Mode: When enabled, the /P command (Define Parameters) is suppressed. This
RPB+; Remote Power Boot Switch -- User's Guide
file:///C|/WEBPAGE/guides/rpbp/build/rpbpguid.htm (4 of 12) [3/9/2000 5:08:10 PM]