Whistler 2000 Power Supply User Manual


 
OPERATION SUMMARY
When in use, make certain that the inverter is proper-
ly ventilated.
Do not use the inverter near flammable materials,
fumes, or gases.
Always operate the inverter in accordance with the
instructions in this manual. Failure to do so may result
in property damage, personal injury, or loss of life.
While connecting the inverter to the power source,
make certain that the inverter is well removed from
any potential source of flammable fumes or gases.
Direct connection of the 2000 model inverter to a dis-
tribution panel is to be made by a licensed electrician
only.
Always ground the inverter before operating it.
In the event a continuous audible alarm or automatic
shut off, turn the inverter OFF immediately. Do not
restart the inverter until the source of the problem has
been identified and corrected.
27
OPERATION SUMMARY
If the rated power consumption of the equipment is in
the range of the maximum specified wattage of your
c o n v e rt e r, test the inverter to ensure that it will operate
p ro p e r l y.
B e f o r e attempting to use a battery charger see page 19.
B e f o re attempting to use medical equipment see page
8 .
Use the heaviest gauge wire (smaller the number, the
larger or heavier the cable) available to connect the
inverter to the power source.
When operating the inverter with the engine off, start the
engine every 30 to 60 minutes and let it run for at least
10 minutes to re c h a r ge the battery.
In the event of automatic shut down, turn the invert e r
OFF (O) immediately. Do not re s t a r t the inverter until the
s o u r ce of the problem has been identified and corre c t -
e d .
To avoid battery drain always disconnect the inverter
when the vehicle is not in use for long periods.
Do not expose the inverter to moisture.
Avoid placing the inverter near sources of heat or in
direct sunlight.
26
1250/1750/2750 Manual 3/6/02 2:45 PM Page 29