Filter
Top Products
Operation
Command Summary
Release 3.1 41
Command Summary
Use these commands to control the operation of the supply. They are listed here in
order of function such as PROGRAMMING, QUERY, CALIBRATION, and
STATUS commands. See “Command Reference” on page 44 for more detailed
information about each command and its use.
Table 3.3 Programming Commands
Command Description
AUXA Selects the state of the AUXA output signal on the J7-7 connector.
AUXB Selects the state of the AUXB output signal on the J7-8 connector.
CLR Initializes the power supply to its Power ON (PON) state.
DLY Sets a programmable time delay which is executed by the supply
before reporting fault conditions after a new output voltage or current is
specified.
GTL Sends the supply to local mode.
FOLD Sets foldback mode for the supply.
HOLD Enables or disables voltage/current setting hold mode for the supply.
IMAX Sets an upper soft limit on the programmed output current for the
supply.
ISET Sets the output current of the supply in amps (default) or in milliamps.
LLO Local Lockout. Disables the front panel LOCAL button.
OUT Enables or disables voltage/current output for the supply.
OVSET Sets the over voltage protection trip point for the supply in volts
(default) or in millivolts.
REN Sets remote mode or local mode.
RST Resets the supply to the present voltage and current settings if the
output is disabled by OVP or foldback protection.
TRG Implements programmed voltage and current settings which had been
in hold mode.
VMAX Sets an upper soft limit on the supply’s programmed output voltage.
VSET Sets the output voltage of the power supply in volts (default) or in
millivolts.