Filter
Top Products
Xerox Nuvera
®
100/120/144 EA Digital Production System - Customer Expectations Document
- 15 -
System Configuration and Installation
Installation Preparation Document
This section should be used in conjunction with the Xerox Nuvera
®
100/120/144 EA Digital
Production System Installation Planning Guide (IPG), the Xerox Nuvera
®
100/120/144 EA Digital
Production System Installation Preparation Document (IPD), and the supported inline DFA Finishing
Device Solution Planning Guide, which contain detailed specifications for size, weight, electric, and
environmental conditions. Only the most important requirements are stated here.
Customer Responsibilities
The following must be completed before system delivery and will be assessed in the final site check:
Item Comments
Identify placement of the system
Ensure the printer can be delivered to the
site
Supply the appropriate electrical connections Dedicated power required
Install an exhaust duct to vent hot air to the
air system or the outside if required
Heat vent kit is available (for stationary system
installations only). The kit lowers the system’s output
from the nominal running heat emission level (see the
Environmental Factors table) to 8,500 BTU/hr.
Install a network drop for Internet access Automatic upload of data for remote diagnostics
Verify the strength and slope of the floor
Meet room Environmental Specifications for
temperature and relative humidity year round
This is essential to the system’s ability to perform as
expected; Xerox will not be able to resolve
performance problems encountered when the area is
not maintained within this operating range.
Connect system to network including proxy
server information
System Installation
System installation can take from 4 to 6 hours for a basic system, to 9 to 11 hours or more, depending
on the number of feeders, finishers and system options being installed.
Availability
As with any other printing process, you will not plan production to the raw speed of the printer.
Your Xerox Nuvera
®
100/120/144 EA Digital Production System will be available to you on a monthly
average 92% to 95% of the time.
• Availability is defined, as all the time the machine is not being serviced or waiting for service by
Xerox.
• Given similar service coverage, DocuTech® / DocuPrint® availability averages up to 95%.
Although the service call rate may exceed current DocuTech
® products in the same speed range,
overall system availability will become comparable.
Planning for volume requires taking many factors into account in addition to printer availability. These
factors include pre-press workflow efficiency, job type and client expectations, use of qualified stocks,
daily volume and number of jobs, job mix, area coverage, adherence to environmental specifications,
and operator expertise and attention to procedures.