Filter
Top Products
PRINTER SPECIFICATIONS AND REQUIREMENTS
XEROX DOCUPRINT 4050/4090 IPS INSTALLATION PLANNING GUIDE 6-15
Figure 6-9. T-shaped turn
1 Passage A
2 Passage B
Figure 6-10. L-shaped turn
1 Passage A
2 Passage B
Using the turning radius table To use the following table:
1. Measure the minimum width of the passage or doorway you
need to use. This is Passage A.
2. Find that number (or the next higher number) in the turning
radius table and read across to the corresponding minimum
value for Passage B, depending on the type of turn the
equipment must negotiate.