Filter
Top Products
PRINTER SPECIFICATIONS AND REQUIREMENTS
XEROX DOCUPRINT 4050/4090 IPS INSTALLATION PLANNING GUIDE 6-17
Printer hardware specifications and requirements summary
The following table summarizes the specifications and electrical
requirements of your printer hardware components.
For a summary of controller hardware specifications and
requirements, refer to the “Controller specifications and
requirements” chapter of this guide. Contact your service
representative if you have questions not specifically addressed in this
guide.
Table 6-10. Printer specifications and power requirements—
4050/4090 printer
Device
Dimensions (depth,
width, height) Weight Heat dissipation Power requirements
4050/4090 printer:
Standard (two-tray)
feeder and dual stacker
d=34.5 in. / 87.6 cm
w=91.5 in. / 232 cm
h=41 in. / 104 cm
Total space
required:
163.5 by 106.5 in. /
415 by 271 cm
1,272 lbs. /
578 kg
4050 (60 Hz) and
4050 (50 Hz DELTA):
Operating: 11,200 BTU
per hour
Standby: 7,400 BTU
per hour
4090 (60 Hz) and
4090 (50 Hz DELTA):
Operating: 14,980 BTU
per hour
Standby: 9,100 BTU
per hour
4050 (60 Hz):
120/208 VAC or
120/240 VAC, 30 amp
Oper. max: 4.1 KVA
Standby: 2.7 KVA
NEMA 14-30R
4050 (50 Hz DELTA):
200, 230, 240 VAC
(3-phase, 4 wire or
single-phase), 30 amp
Oper. max: 3.8 KVA
Standby: 2.5 KVA
4090 (60 Hz) and
4090 (50 Hz DELTA):
Oper. max: 5.5 KVA
4050/4090 printer:
Standard (two-tray)
feeder and stitcher/
stacker
d=34.5 in. / 87.6 cm
w=89.5 in. / 227 cm
h=41 in. / 104 cm
Total space
required:
161.5 by 106.5 in. /
410 by 271 cm
1,274 lbs. /
579 kg
Same as 4050/4090
standard (two-tray)
feeder and dual stacker
configuration, above.
Same as 4050/4090
standard (two-tray)
feeder and dual stacker
configuration, above.
4050/4090 printer:
High-capacity feeder
and dual stacker
d=34.5 in. / 87.6 cm
w=114 in. / 290 cm
h=41 in. / 104 cm
Total space
required:
184 by 106.5 in. /
467 by 271 cm
1,560 lbs. /
709 kg
Same as 4050/4090
standard (two-tray)
feeder and dual stacker
configuration, above.
Same as 4050/4090
standard (two-tray)
feeder and dual stacker
configuration, above.