Filter
Top Products
DOCUSP 3.x
16 XEROX DOCUMENT SERVICES PLATFORM SERIES
GETTING READY FOR THE DOCUSP INSTALLATION
W-6 data element definitions
This section defines the data elements determined by the
network administrator or the Xerox Systems Analyst during the
setup of the NetWare Gateway on each Novell Server that will
be transferring documents from Novell clients to the controller.
To support a smoother, faster install process, make sure these
data elements are known and entered in this worksheet before
the scheduled day of installation.
Novell Internal network number: This is the internal network
number, assigned to the controller, that identifies the DocuSP
controller on the Novell network. This data element must be a
new, eight digit hexadecimal number, that is a unique number on
the Novell network, and is available from the network
administrator.
NOTE: If necessary, pad the number with zeros from the left to
achieve the eight digits.
Novell network number: This is an eight digit, hexadecimal
network number that identifies the Novell network. The external
network number can be any number defined that falls within the
range of 1 to FFFFFFFFE.
NOTE: This number must be the same on both the Novell server
and the controller.
You can find the Novell network number by entering the
CONFIG command at the Novell File Server system console
prompt, as in the following Frame type ETHERNET_802.3
example. The network number is in bold, on the last line of this
example, as the LAN protocol IPX network number, and may
also be referred to as the Ethernet Net Number.
File server name: Cust 2
IPX internal network number: 0123A.B09
Novell NE2000
Version 3.25 June 17, 1993
Hardware setting: I/O Port 300h to 31Fh,
Interrupt 3h
Node address 00009B99E999
Frame type: ETHERNET 802.3
Boardname: PUBLIC
LAN protocol: IPX network 0000BB09
At this point make a note of the name of the file server since it
will be needed later. This information will appear after the entry,
File server name:. The comparable ETHERNET_Il entry would
look like the follow example. In the following example the name
of the file server is Cust_2 and the network number is in bold, on
the last line as the LAN protocol IPX network number.
Remember, this is an example, and your setup will most likely be
different.
File server name: Cust 2
IPX internal network number: 0123AB09