Filter
Top Products
4 Handling The Printer
90 8254E / 8264E User Guide
4.6.1.1.1 User media menu
Allows you to set up the configuration of various settings for the media being used. Configurations can
be set for thirty different media in the User media menu.
• If media other than a recommended one is used, the following problems may occur.
• Media detection error
• Slant, snag and wrinkle of media
• Media jams
• Favorable print quality cannot be obtained due to blots, blurs or dirt.
• End detection of roll media cannot be performed.
The problems caused by the use of unrecommended media will not be covered by the
warranty and repair expenses will be paid by the customer. For details, contact your
local XEROX dealer.
Setup item Setting Description
Type 1 to Type 30 Print Mode Sets up the print mode according to the usage of print
data or print speed.
• Pressing the [Enter] key shifts to the sub menu.
4.6.1.1.2 Print Mode menu
PF Adjust Allows configuration of various Media feed
compensation settings.
• Pressing the [>] key: shifts to the sub menu.
4.6.1.1.3 PF Adjust menu
Pre-Heater Sets up the Pre-Heater temperature.
• Pressing the [Enter] key shifts to the sub menu.
4.6.1.1.4 Pre-Heater menu
Platen Heater Sets up the Platen Heater temperature.
• Pressing the [Enter] key shifts to the sub menu.
4.6.1.1.5 Platen Heater menu
After Heater Sets up the After Heater temperature.
• Pressing the [Enter] key shifts to the sub menu.
4.6.1.1.6 After Heater menu
StandbyHeating Sets up the length of time to preheat the heater while the
printer is in standby mode.
• Pressing the [Enter] key shifts to the sub menu.
4.6.1.1.7 StandbyHeating menu
Vacuum Fan Sets up the vacuum fan operation.
• Pressing the [Enter] key shifts to the sub menu.
4.6.1.1.8 Vacuum Fan menu
—
• Pressing the [Cancel] key shifts to the previous menu.
4.6.1.1 MediaType menu