Filter
Top Products
4 Handling The Printer
98 8254E / 8264E User Guide
4.6.1.2.2 8254E Effect menu
Effect (cont.) A-S.Fine&Wave Performs "Wave" printing using only one side of the
print head’s nozzles (designated as the A
side).
Since only half of the print head’s nozzles are used, the
time to print is twice as long as it is when "Wave 1, 2, 3,
or 4" is used.
Set up this menu if you need to improve the print quality
compared with "Fine&Wave 1 to 4."
B-S.Fine&Wave Same as immediately above. Performs "Wave" printing
using only half of the print head’s nozzles but uses the
other
side nozzles (designated as the B side).
Again, since only half of the print head’s nozzles are
used, the time to print is twice as long as it is when
"Wave 1, 2, 3, or 4" is used.
Set up this menu if you need to improve the print quality
compared with "Fine&Wave 1 to 4."
—
• Pressing the [Enter] key saves the setting and shifts to
the previous menu.
• Pressing the [Cancel] key cancels the setting and
shifts to the previous menu.
4.6.1 Setup menu (Setup item 1 of 7 total)
Setup item Setting Description
Effect None 1 The Effect function is not used.
If obvious white lines or uneven print density appear on
printed media while set at "None 1," set to "None 2."
None 2
Wave 1 The printing joint will be the wave form.
It should result in improved print quality.
If obvious white lines or uneven print density appear on
printed media while set at "Wave 1," change the setting
to "Wave 2."
Wave 2
Fuzz 1 The printing joint will shade off as the wave form.
If obvious white lines or uneven print density appear on
printed media in "Wave," set to "Fuzz 1."
If obvious white lines or uneven print density appear on
printed media in "Fuzz 1", set to "Fuzz 2."
Fuzz 2
<Fine&Wave 1> Performs printing at a slower speed than "Wave."
Set up this menu if you"need to improve the print quality
compared with "Wave."
If obvious white lines or uneven print density appear on
printed media in "Fine&Wave 1," change the setting to
"Fine&Wave 2, 3, or 4" ... whichever one produces the
best result.
Fine&Wave 2
Fine&Wave 3
Fine&Wave 4
A-S.Fine&Wave Performs "Wave" printing using only one side of the
print head’s nozzles (designated as the A
side).
Since only half of the print head’s nozzles are used, the
time to print is twice as long as it is when "Wave 1, 2, 3,
or 4" is used.
Set up this menu if you need to improve the print quality
compared with "Fine&Wave 1 to 4."
Setup item Setting Description