Filter
Top Products
Connecting to System
Xerox FS 3270, User's Guide
- 16 -
If all three (a. b. and c.) are in order, contact your systems support
personnel or your dealer.
PCL driver:
The default configuration of the interface will suffice for most
application programs and uses. You should only change the
configuration if you have special requirements.
If you should wish to change the configuration, the options may be
set from the line as described in the Programmer's Guide;
document no. D62078, subpart D62030
FSL Driver
With the FSL driver you have selected an unprogrammed printer
driver. You have to program the internal setup of the box to suit
your printing requirements. See Programmer's Guide; document
no. D62078, subpart D62071 for further details.
2.4.1. Testing
1. Power the unit ON.
2. Turn the rotary switch to the “T” position and back to the original
position. This will generate a settings printout.
3. When the switch has been turned back to its original position, the
CU indicator will start flashing for approximately 30 seconds.
4 Turn the rotary switch to the “T” position once again while the CU
indicator is flashing. The unit will now enter Online HEX dump
mode. The dump mode is terminated by turning the switch away from
the “T” position and back into the “T” position.
NOTE:
The CU indicator will be blinking rapidly while the rotary
switch is in the “T” position. This is an indication that the
“T” position is not a valid permanent position.
5. Compare the test printout (FSL or PCL printout) with the rele vant
printout in Chapter 10, Test Printout.