Filter
Top Products
Direct Console Management
When you can see the self-test messages shown on screen properly, you can press <Enter> key to start
console login operation. Go to Login Prompt section in next page directly.
Telnet Management
Use Telnet software to perform the management operation. The most convenient solution is using the
built-in Telnet function in a Windows 95/98/ or NT PC. Enter into DOS window and invoke Telnet
command :
>telnet xxx.xxx.xxx.xxx
to connect to the device. The specified xxx.xxx.xxx.xxx is the IP address of the device. Factory default IP
address is 192.168.0.2.
A welcome message and login prompt are displayed if the connection is established properly.
Login Prompt
The following figure illustrates the login screen:
----------------------------------------------------
User Interface
Managed 24 + 2G Switch
login:xxxx
password:xxxx
----------------------------------------------------
Username : admin
Factory default Password : 123
For security reason, the device supports a function to change the password in setup menu. It is
recommended to change the default password immediately after a successful login.