Filter
Top Products
STP Enable
----------------------------------------------------
Managed 24+2G Switch : STP Enabled/Disabled Configuration
STP : Enabled
action-> <Edit> <Save> <Quit>
----------------------------------------------------
Spanning Tree function can be enabled or disabled. Press Space key to select enable or disable.
System Configuration
----------------------------------------------------
Managed 24+2G Switch : STP System Configuration
Root Bridge Information Configure Spanning Tree Parameters
------------------------------ ------------------------------
Priority : 32768 Priority (0-65535) :32768
Mac Address : 0040F6FE0008
Root_Path_Cost : 0 Max Age (6-40) :20
Root Port : Root
Max Age : 20 Hello Time (1-10) :2
Hello Time : 2
Forward Delay : 15 Forward_Delay_Time (4-30) :15
action-> <Edit> <Save> <Quit>
----------------------------------------------------
Current spanning tree information about the Root Bridge is shown on the left side and new values for
STP parameters are configured on the right side.
The settings are:
Priority : The priority is assigned to the switch. The higher value is lower priority. Range: 0 - 65535
Max Age : The number of seconds a bridge waits without receiving Spanning Tree protocol configuration
messages before attempting a reconfiguration. Valid value : 6 ~ 40.
Hello Time : The number of seconds between the transmission of Spanning Tree protocol configuration
messages. Valid value : 1 ~ 10.
Forward Delay Time : The number of seconds a port waits before changing from its Spanning Tree
Protocol learning and listening states to the forwarding state. Valid value : 4 ~ 30.
For descriptions of STP status and parameters, refer to Chapter 1 - Spanning Tree Protocol section.