Filter
Top Products
75 En
ADJUSTING SYSTEM PARAMETERS
ADVANCED
OPERATION
English
4 Press / to switch between DEMO: ON
and DEMO: OFF.
• Select DEMO: ON to activate the demo mode.
• Select DEMO: OFF to deactivate the demo mode.
5 Press STANDBY/ON on the front panel to set
this unit to the standby mode.
The new setting will be activated when you turn on
the power of this unit next time.
Press ENTER to test the sound beam.
The sound beam being output shuttles between left
and right. Press ENTER again to stop shuttling.
You can reset all of the parameters of this unit to the
factory presets. This procedure completely resets ALL the
parameters in SET MENU.
After performing the following procedure you must run the
AUTO SETUP again to match your surround sound environment.
1 Repeat steps 1 to 3 in “Using the system
parameters” on page 72.
2 Set the operation mode selector to YSP to
switch to the operation mode of this unit.
3 Press / on the remote control so that
FACTORY PRESET is shown in the front
panel display.
4 Press ENTER.
ENTER
VOL
DEMO: ON
VOL
DEMO: OFF
STANDBY/ON
Setting the FACTORY PRESET
Note
YSP
TV/AV
ENTER
VOL
FACTORY PRESET
ENTER