Filter
Top Products
Configuration
Standard Control Panel Parameters
110
P1009874-002 Xi4™/RXi4™ User Guide 1/7/10
Set Reprint Mode
When reprint mode is enabled, you can reprint the last label printed either
by issuing the ~PR ZPL command or by pressing MINUS (-) on the control
panel.
Default Value: DISABLED
Selections: ENABLED, DISABLED
To change the value shown:
1. Press PLUS (+) or MINUS (-) to toggle between the options.
See next column View Sensor Settings
These parameters are automatically set during the calibration procedure
and should be changed only by a qualified service technician. Refer to the
Programming Guide for ZPL, ZBI, Set-Get-Do, Mirror, and WML for
information on these parameters.
To skip these parameters:
1. Press NEXT/SAVE to skip each of the following parameters:
Table 8 • Printer Parameters (Sheet 20 of 22)
Language/Parameter
Action/Explanation