users: select Run from the Start menu.)
5. Type A:\SETUP (or B:\SETUP) and then press OK.
6. Follow the on-screen instructions to complete the installation.
To create a label for the A100 printer, you will need to design the label in a
Windows application (such as BAR-ONE) and use that application’s print
setup to select the Zebra A100 printer before you print. Alternatively, you
may use the Windows Printers Control Panel to select the Zebra A100 as
your default printer for all your Windows applications. The Zebra A100
printer driver works like any other printer driver: by selecting the Zebra
A100 printer in Print Setup or in the Windows Printers Control Panel you can
print from most Windows applications to this printer.
The operator tears off each label (or a strip of labels) as
it is printed.
The backing material is peeled away from the label as it
is printed, the printer waits until the operator removes the label, then the next
label is printed.
Located on the right-hand side of the printer near the
back. The power switch should be turned off before connecting or discon-
necting any cables.
In normal use, pressing the Feed Key once when the printer is
idle (not printing) will cause the printer to feed a blank label. Holding the
Feed Key while turning the power on and for 2 seconds afterward causes a
test pattern to print. See Figure 4. This test pattern allows your to quickly
confirm that the printer is working without connecting it to a computer.
55501lr3 Page 14 Wednesday, March 26, 1997 1:08 PM