Filter
Top Products
29
QL Series User Guide
If you have a printer equipped with the Kickstand option, you
must first remove the belt clip retainer as shown in Figure 14,
retaining the two screws holding the retainer to the lower cov-
er. Arrange the communications cable in a broad loop as de-
tailed above, and capture it in the strain relief feature on the
bottom of the belt clip retainer. Then re-secure the belt clip
retainer to the bottom cover of the printer.
Figure 14: Communications Strain Relief with Kickstand option
Kickstand is not shown in this view for clarity
1. Remove Belt Clip
Retainer, along with Belt
Clip and Kickstand.
2. Press communications
cable into strain relief
feature on bottom of Belt
Clip
3. Reassemble Belt Clip to
bottom cover.