Filter
Top Products
Chapter 1: Installation Instructions 19
Tip:
If you do not know your Username and Password,
contact your service provider and tell them that you
misplaced the information.
¾ If your Encapsulation setting begins with 1483
Bridged or 1483 Routed: The Username and Password
boxes will automatically disappear from the page because
you do not need to enter this information. Continue with
step 5.
Important!
If you plan to use a static IP address, you must manually
configure the X5 from the WAN Configuration page and
not the Basic Setup page. For more information, see
Using Static IP Addressing on page 20. Typically, you
must make arrangements with (and pay) your Internet
service provider for a static IP address.
5 In the VPI and VCI boxes, enter the settings for your service
provider.
6 Click Save Changes and then Write Settings to Flash. Once
the process is complete, the X5’s DSL light should remain on
steady (this should take about 15 seconds).
7 Verify that your Internet connection is working. Open your
Web browser and try to connect to a familiar Web address.
If you connect successfully, your installation is complete
and you are ready to browse the Web!
If you want to connect more computers or a network device to
the X5, continue with Connecting Additional Devices to
the Internet on page
22. Otherwise, you are done with this
user’s guide. Enjoy your X5!