Filter
Top Products
56 ADSL X3 User's Guide
•
Verify that your service provider’s ADSL connection is
functioning properly. (Place a call to your service provider’s
customer support department to verify this.)
•
Verify that your TCP/IP network settings are properly
configured on your computer. To do this, refer to the
appropriate section.
!
If you are using Macintosh, see Macintosh TCP/IP
Settings on page 49.
!
If you are using Linux, see Linux TCP/IP Settings on
page 51.
!
If you are using Windows, see Windows TCP/IP
Settings on page 52.
Problem
My X3’s LINK light continually blinks and does not stay solidly lit.
Solution
There are several issues that could cause this problem. Check these
items:
•
Ensure that the phone cord is firmly plugged into the wall jack
and the ADSL jack on the back of the X3 (not the PHONE
jack on the back of the modem).
•
Verify that the jack the phone cord is connected to is enabled
for ADSL service. Unless your service provider has enabled it,
you cannot use a standard telephone jack for ADSL service.
•
Your phone cord may be defective. Replace the phone cord
with a known good one.
•
You have installed phone filters on all the phones and fax
machines using the same ADSL line as the X3. These devices
can produce noise and interfere with your ADSL connection.