Filter
Top Products
Dimension ES-3024 Ethernet Switch
Commands Introduction 21-9
COMMAND DESCRIPTION
gvrp <port> <enable|disable>
Enables/disables GVRP on the
specified port.
svlan cpu <vlan id>
Sets the VLAN ID of the
management VLAN (CPU).
setentry<name><vid><port><adctl>
<tagctl>
Applies a static VLAN (name,
admin control tag, tag control) to
a port.
delentry <vid>
Deletes the specified (VID) static
VLAN.
active <vid>
Turns on the specified static
VLAN.
inactive <vid>
Turns off the specified static
VLAN.
list
Displays a table of static VLANs.
vlan list <all|vid|start_vid end_vid>
Shows the specified IEEE
802.1Q Tagged VLAN table.
status
Shows the IEEE 802.1Q tagged
status.
driver
config
Shows the switch’s settings.
count
disp
Shows the switch Network Driver
Interface Specifications (NDIS)
level counters (CPU interface).
clear
Clears the switch NDIS level
counters (CPU interface).
rstp
All “sys sw rstp” commands
relate to rapid STP configuration.
Refer to IEEE Std 802.1w. Use
“config save” to save your
configuration changes.
bridge
enable
Enables RSTP.
disable
Disables RSTP.
priority <priority>
Sets the system priority.
maxage <max age>
Sets the max age timer
hellotime <hello time>
Sets the hello timer.
forwarddelat <forward delay time>
Sets the forward delay time
version <stp:0|rstp:2>
Displays/enables the STP mode;
STP or RSTP. RSTP is the
default used when configuring
STP via web configurator.
port
enable <port_no>
Enables RSTP on this port.
disable <port_no>
Disables RSTP on this port.