Filter
Top Products
Dimension ES-3024 Ethernet Switch
SNMP Setup 14-3
Figure 14-2 SNMP Setup
The following table describes the SNMP configuration parameters.
Table 14-2 SNMP Setup
LABEL DESCRIPTION
Get Community Enter the get community, which is the password for the incoming Get- and GetNext- requests
from the management station.
Set Community Enter the set community, which is the password for incoming Set- requests from the
management station.
Trap: Community Enter the trap community, which is the password sent with each trap to the SNMP manager.
Trap: Destination Enter the IP addresses of up to four stations to send your SNMP traps to.
Click Apply to save your changes back to the switch or click Cancel to begin configuring this screen afresh.
14.4 SNMP Traps
The ES-3024 sends traps to an SNMP manager when an event occurs. SNMP traps supported are outlined in the
following table.
Table 14-3 SNMP Traps
GENERIC TRAP SPECIFIC TRAP DESCRIPTION
0 (Cold Start) 0 This trap is sent when the ES-3024 is turned on.
1 (WarmStart) 0 This trap is sent when the ES-3024 restarts.