ZyXEL Communications GS-3012F/3012 Switch User Manual


 
GS-3012/GS-3012F User’s Guide
207
CHAPTER 25
Two Rate Three Color Marker
This chapter describes how Differentiated Services (DiffServ) fits into a quality of service
strategy and shows you how to configure Two Rate Three Color Marker traffic policing on the
Switch.
25.1 DiffServ Overview
Quality of Service (QoS) is used to prioritize source-to-destination traffic flows. All packets in
the flow are given the same priority. You can use CoS (class of service) to give different
priorities to different packet types.
DiffServ is a class of service (CoS) model that marks packets so that they receive specific per-
hop treatment at DiffServ-compliant network devices along the route based on the application
types and traffic flow. Packets are marked with DiffServ Code Points (DSCPs) indicating the
level of service desired. This allows the intermediary DiffServ-compliant network devices to
handle the packets differently depending on the code points without the need to negotiate paths
or remember state information for every flow. In addition, applications do not have to request
a particular service or give advanced notice of where the traffic is going.
25.1.1 DSCP and Per-Hop Behavior
DiffServ defines a new DS (Differentiated Services) field to replace the Type of Service (ToS)
field in the IP header. The DS field contains a 6-bit DSCP field which can define up to 64
service levels and the remaining 2 bits are defined as currently unused (CU). The following
figure illustrates the DS field.
Figure 116 DiffServ: Differentiated Service Field
DSCP is backward compatible with the three precedence bits in the ToS octet so that non-
DiffServ compliant, ToS-enabled network device will not conflict with the DSCP mapping.
The DSCP value determines the PHB (Per-Hop Behavior), that each packet gets as it is
forwarded across the DiffServ network. Based on the marking rule different kinds of traffic
can be marked for different priorities of forwarding. Resources can then be allocated
according to the DSCP values and the configured policies.
DSCP (6 bits) CU (2 bits)