Filter
Top Products
Chapter 6 Routing
LTE6100 User’s Guide
47
6.2.1 Add/Edit Static Route
Click add new Static Route in the Routing screen or click the Edit icon next to a rule. The
following screen appears. Use this screen to configure the required information for a static route.
Figure 23 Routing: Add/Edit
The following table describes the labels in this screen.
Table 14 Routing: Add/Edit
LABEL DESCRIPTION
Active Click this to activate this static route.
Route Name Enter the name of the IP static route. Leave this field blank to delete this static route.
Destination IP
Address
This parameter specifies the IP network address of the final destination. Routing is always
based on network number. If you need to specify a route to a single host, use a subnet
mask of 255.255.255.255 in the subnet mask field to force the network number to be
identical to the host ID.
IP Subnet Mask Enter the IP subnet mask here.
Gateway IP
Address
You can decide if you want to forward packets to a gateway IP address or a bound
interface.
If you want to configure Gateway IP Address, enter the IP address of the next-hop
gateway. The gateway is a router or switch on the same network segment as the device's
LAN or WAN port. The gateway helps forward packets to their destinations.
Bound Interface You can decide if you want to forward packets to a gateway IP address or a bound
interface.
If you want to configure Bound Interface, select the check box and choose an interface
through which the traffic is sent.
Apply Click Apply to save your changes.
Back Click Back to exit this screen without saving.