Filter
Top Products
P-660H-Tx v2 Quick Start Guide
4
•The POWER light blinks while your P-660H-Tx v2 starts up and stays on once it is ready.
•The DSL light is on when the P-660H-Tx v2 has a DSL connection.
•The INTERNET light is on when you are able to access the Internet and blinks when the P-660H-Tx v2 is send-
ing or receiving data.
• Each ETHERNET light stays on if the corresponding ETHERNET port is properly connected and blinks when
there is traffic.
If any of these lights are not on, check your connections, and inspect your cables for damage. If the lights are
still off, contact your local vendor.
2 Internet Connection Setup: Automatic
Use this section to have your P-660H-Tx v2 automatically detect and set up your Internet connection.
1 Open your web browser, and go to any web page (for example, http://www.zyxel.com). Your P-660H-Tx v2
tries to detect your Internet connection.
2 Wait for the P-660H-Tx v2 to finish the connection test. This may take several minutes. If you do not see a
connection test screen similar to the following, go to step 5.
3 If the connection test is successful, the following screen appears. Your Internet connection is ready for you
to use.