Filter
Top Products
Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
4-12 NAT
FIELD DESCRIPTION EXAMPLE
Action
The default is Edit. Edit means you want to edit a selected
rule (see following field). Insert Before means to insert a rule
before the rule selected. The rules after the selected rule will
then be moved down by one rule. Delete means to delete the
selected rule and then all the rules after the selected one will
be advanced one rule. None disables the Select Rule item.
Edit
Select Rule
When you choose Edit, Insert Before or Delete in the
previous field the cursor jumps to this field to allow you to
select the rule to apply the action in question.
1
You must press [ENTER] at the bottom of the screen to save the whole set. You
must do this again if you make any changes to the set – including deleting a rule.
No changes to the set take place until this action is taken.
Selecting Edit in the Action field and then selecting a rule brings up the following menu, Menu 15.1.1.1 -
Address Mapping Rule in which you can edit an individual rule and configure the Type, Local and Global
Start/End IPs.
An End IP address must be numerically greater than its corresponding IP Start
address.
Figure 4-9 Menu 15.1.1.1 — Editing/Configuring an Individual Rule in a Set
Menu 15.1.1.1 Address Mapping Rule
Type= One-to-One
Local IP:
Start=
End = N/A
Global IP:
Start=
End = N/A
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.