Filter
Top Products
Prestige 314 PLUS Broadband Sharing Gateway with 4-Port Switch
5-8 Remote Node Setup
The next table gives you instructions about configuring remote node network layer options.
Table 5-4 Remote Node Network Layer Options Menu Fields
FIELD DESCRIPTION EXAMPLE
IP Address
Assignment
If your ISP did not assign you an explicit IP address, select
Dynamic; otherwise select Static and enter the IP address & subnet
mask in the following fields.
Dynamic
Rem IP
Address
If you have a Static IP Assignment, enter the IP address assigned to
you by your ISP.
Rem IP
Subnet
Mask
If you have a Static IP Assignment, enter the subnet mask assigned
to you.
My WAN
Addr
If you have a Static IP Assignment, enter the gateway IP address
assigned to you.
Network
Address
Translation
Use the [SPACE BAR] to select either Full Feature, None or SUA
Only. See the NAT chapter for a full discussion of this feature.
SUA Only
Metric This field is valid only for PPTP/PPPoE encapsulation. The metric
represents the “cost” of transmission for routing purposes. IP routing
uses hop count as the measurement of cost, with a minimum of 1 for
directly connected networks. Enter a number that approximates the
cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.
3
Private This field is valid only for PPTP/PPPoE encapsulation. This
parameter determines if the Prestige will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept
private and not included in RIP broadcast. If No, the route to this
remote node will be propagated to other hosts through RIP
broadcasts.
Yes
RIP
Press the [SPACE BAR] to select the RIP direction. Options are:
Both, None, In Only, Out Only or None. Please see the RIP Setup
section for more information on RIP. The default for RIP on the WAN
side is None. It is recommended that you do not change this setting.
None
(default)
Version
Press the [SPACE BAR] to select the RIP version. Options are RIP-
1, RIP-2B or RIP-2M.
None