Filter
Top Products
Chapter 26 Static Route
XGS-4728F User’s Guide
228
Metric The metric represents the “cost” of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number need
not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Add Click Add to insert a new static route to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to set the above fields back to the factory defaults.
Index This field displays the index number of the route. Click a number to edit the static
route entry.
Active This field displays Yes when the static route is activated and NO when it is
deactivated.
Name This field displays the descriptive name for this route. This is for identification
purposes only.
Destination
Address
This field displays the IP network address of the final destination.
Subnet Mask This field displays the subnet mask for this destination.
Gateway
Address
This field displays the IP address of the gateway. The gateway is the immediate
neighbor of your Switch that will forward the packet to the destination.
Metric This field displays the cost of transmission for routing purposes.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
Table 83 IP Application > Static Routing (continued)
LABEL DESCRIPTION