Page 5-13CONFIGURATION OPTIONS
55 MD-Laser Support
Determines whether or not the ULTRA will provide Maersk Data Products
continuous escape support. Select Yes if using Maersk Data software. If
this option is set to Yes, when the three-character sequence Esc C 2 is
detected in the data stream, the hexadecimal value of the character pairs
following the sequence will be sent to the printer until a terminator (Esc) is
detected. The default value is No. Refer to Section 11 Transparency
Modes for more information.
Note: If this option is set to Yes, Option #1 Column width should be
set to 0 (infinite line length), Option #2 Lines Per Page should be set to 0
(infinite page length), and Option #15 Bold Print Emulation should be
set to C (none). Otherwise, unpredictable formatting errors could occur.
Refer to Section 12 DisplayWrite 370 Support for more information.
56 Reserved
This option is reserved.
57 DSC NL at EM Even If in Column 1
IBM specifications state that the EM (End of Message) character will have
the effect of sending a CR/LF to the printer when the printhead is in any
column other than column one. Setting this option to No causes the
ULTRA to conform to this IBM specification, while setting it to Yes
causes a CR/LF to be sent to the printer whenever an EM is received,
regardless of the printhead position. The default value is No. Refer to
Section 15 DSC Data Streams for more information.
58 Metacode Support
Metacode is a variation of 35 Hex transparency. If this option is set to
Yes, Metacode support is enabled. If set to No, 35h will be ignored.
The default value is No. Refer to Section 11 Transparency Modes and
Section 16 Xerox Applications for more information.
Note: If this option is set to Yes, Option #1 Column width should be
set to 0 (infinite line length), Option #2 Lines Per Page should be set to 0
(infinite page length), and Option #15 Bold Print Emulation should be
set to C (none). Otherwise, unpredictable formatting errors could occur.
Refer to Section 12 DisplayWrite 370 Support for more information.
