18
PROGRAMMING THE VSSI-PRO
IP ADDRESS 1 192
IP ADDRESS 2 168
IP ADDRESS 3 0
IP ADDRESS 4 141
EXIT
Figure 19: TCPIP FORMAT I Sub-Menu
2. Press the “Up” or “Down” button to move the cursor to “EXIT” and press “Set” to return to the previous menu.
3. Test your transaction on the ATM to verify the VSSI-Pro and TCPIP 232 Adapter’s operation.
TCPIP 232 DEBUGGING MODE
In the TCPIP DEBUGGING mode, the data from the network will display on the monitor. However, the VSSI-Pro has a
limited buffer size so if you connect to a busy network and the buffer is overrun, then data will be lost. For normal ATM
data, the buffer is sufficient but care must be taken in monitoring the buffer status when doing data dumps. This is useful
to verify the TCPIP 232 Adapter is connected properly and sending data to the VSSI-Pro.
1. Press the “Up” or “Down” button to move the cursor to “TCPIP DEBUGGING” and press “Set” to enter and change
the IP address to the same as the ATM’s IP address.
EXAMPLE: If the ATM’s IP address is 192.168.0.141, set the address on the TCPIP 232 Adapter using this
menu.
IP ADDRESS 1 192
IP ADDRESS 2 168
IP ADDRESS 3 0
IP ADDRESS 4 141
EXIT
Figure 20: TCPIP INTERFACE Sub-Menu
Figure 21: TCPIP DEBUGGING Sub-Menu
TCPIP FORMAT I
TCPIP DEBUGGING
EXIT
Figure 18: TCPIP INTERFACE Sub-Menu
1. Press the “Up” or “Down” button to move the cursor to “TCPIP FORMAT I” and press “Set” to enter and change
the IP address to the same as ATM’s IP address.
EXAMPLE: If the ATM’s IP address is 192.168.0.141, set the address on the TCPIP 232 Adapter using this
menu.
TCPIP FORMAT I
TCPIP DEBUGGING
EXIT
VSSI-Pro VIDEO SERIAL ATM INTERFACE
2. Once you select the IP address, press the “Up” or “Down” button to move the cursor to “EXIT” and press “Set” to
return to the the previous menu.
TCPIP 232 ADAPTER LED INDICATOR
GREEN POWER TCPIP 232 Power Status
RED REC EIVETCPIP-232 Receive Data from ATM
GREEN LINK ATM Status, On = Ready / Off = Not ready
YELLOW SPEED Off = 10 Mbps, On = 100 Mbps Ethernet
The TCPIP INTERFACE sub-menu:
