A SERVICE OF

logo

49
PERFORMING A DATA DUMP
1. Make the proper connections as shown.
2. Make sure the PORT 1 communication settings are the same as the computer’s settings.
3. Run a PORT A receiving test (access PORT A submenu in TEST/DEMO of the main programming menu) to make
sure data is being received.
4. Go to DUMP DATA in the PORT A submenu and press “Set”. The data should appear on the computer screen. Save
this data to a file.
Follow the same procedure for performing a data dump from PORT B using the PORT B sub-menu for a receiving test and
the DUMP DATA command.
Figure 1A: Data Dump Connections
DATA DUMP CONNECTIONS
To execute a data dump you will have to connect wires from the DB-9 connector of the VSSI-Pro to either Com 1 or
Com 2 of a computer, using the following pin-out diagram:
Table 1A: Data Dump Connections
DATA DUMP CONNECTIONS APPENDIX A
VSSI-Pro VIDEO SERIAL ATM INTERFACE
SDLC / BISYNC CAMERA PORT / JOURNAL / TCPIP Com 1 (DB-9) Com 2 (DB-25)
3 8 2 3
5 5 5 7
MODEM
VSSI-PRO
DB-9 Connec-
tor
COM 1 (DB-9)
COM 2 (DB-25)
ATM
CAMERA
MONITOR
RG-59U
RG-59U
DB-9 Connec-
tor
Triport